JuanLuisPMI
10-13-2010, 04:34 AM
Hi,
I'm getting crazy with the MFC02 Unit...I've made the training steps 1 and 2 without problems, but now I'm stucked because there is no way trying to reset the unit. I reset twice and no problem, and now that everything is connected and ready to the final steps I try to reset pressing the SW3 at the same time that power on the unit and nothing happens. The only step that works is the second; If I press the SW3 button between 1 and 3 seconds the trim training is correctly done, but I can't do the 1 and 3 steps.
I've tryed reset the unit in multi-mode, rc-mode, lights-mode...nothing! Trims are in neutral position, everything is ok, but, nothing! The worst is I was able to reset with the same configuration; servos, radio...I'm using a Sanwa 4Ch
Any idea or help would be grateful!
Thank you very much
I'm getting crazy with the MFC02 Unit...I've made the training steps 1 and 2 without problems, but now I'm stucked because there is no way trying to reset the unit. I reset twice and no problem, and now that everything is connected and ready to the final steps I try to reset pressing the SW3 at the same time that power on the unit and nothing happens. The only step that works is the second; If I press the SW3 button between 1 and 3 seconds the trim training is correctly done, but I can't do the 1 and 3 steps.
I've tryed reset the unit in multi-mode, rc-mode, lights-mode...nothing! Trims are in neutral position, everything is ok, but, nothing! The worst is I was able to reset with the same configuration; servos, radio...I'm using a Sanwa 4Ch
Any idea or help would be grateful!
Thank you very much